I can answer that (since I've asked Bram the same question offline):
no, station 8 gets no carbon tape.
Warren
On Mon, Apr 05, 2004 at 08:55:53AM -0400, tom owen wrote:
> Morning Bram,
>
> thanks for your reply :)
>
> re stn 8 & half bulkheads - did you add any carbon tape to bulkhead at
> station 8 or to any of the half bulkheads?
>
> everything else clear - thanks.
>
> regards,
> Tom.
> USA020.
>
> -----Original Message-----
> From: BDally6107@xxxxxxx [mailto:BDally6107@xxxxxxx]
> Sent: 04 April 2004 17:58
> To: tom.owen@xxxxxxx
> Cc: swiftsolo@xxxxxxxxxxxx
> Subject: Re: Tom questions :)
>
> Tom
>
> Good to hear from you.
>
> Put carbon tape on one side of station 6 only.
>
> Cut station 8 by measuring the width of your cb trunk and cutting 1/2 of
> that width out of each side from the centerline.
>
> The inner corners of the transom bar line up with the inner corners of
> the steps (see the picture on the cover).
>
> If I've done a poor job of explaining, let me know and I'll try again.
>
> Best regards,
>
> Bram
--
warren stevens - catzooks.com
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|