Roger,
Thats what I did. I used middle and outers. I dont have a tally on the number
of screews I used. I am sticking to 10-24 for everything except the chainplates
where I did 1/4. The lenght will vary but I have been buying 3" and just
cutting them off after I bolted them in.
Christian
----- Original Message -----
From: rowr <rowr@xxxxxxxxx>
Date: Tuesday, May 11, 2004 7:32 pm
Subject: chain plate
> A question about the chainplate. Is it correct that we are using
> rudder gudgeons as deck attachments for the chainplates and if so,
> I presume we use the centre hole and the two outmost holes for
> fitment.
> Secondly, has anyone made a consolidated list of bolts, screws and
> rivets that are used for the deck fittings. I assume also that all
> the bolts, screws and t-nuts are stainless.
>
> regards and good building
> Roger - CAN048
>
>
>
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|