Do you want to get "close to the correct size?" or do you want to adjust them
at this point to compensate for the hybrid?? 1/4" ofset.
On Mon, 11 Jul 2005 19:59:35 EDT, BDally6107 wrote
>
> Steve,
>
> Great video clip by the way. It would be good to critique that video to
> provide some insight about what went right and what went wrong (I have some
> ideas).
>
> Regarding the bulkheads, just lay the particle board station templates on the
> material, drill a couple of small holes and insert some nails or pins to keep
> it in place, and use a utility knife to scribe the material. The knife works
> better than a pencil because you can typically get closer to the correct
> size.
>
> Thanks again for the heads up on the video.
>
> Bram
--
Open WebMail Project (http://openwebmail.org)
|