Steve,
Your picture is the way I did the jig. I used a cedar strip and drilled
some holes for a nail for the fixed end and then a hole for a pencil and
drew it on a 2x10. Here is a picture of the jig I used. I probably
should have used tape around the wet strips before clamping in the press.
It would have helped the strips sliding around. I could have also used a
smaller width, closer to the finished width.
Rob
Transom Jig.pdf
Description: Adobe PDF document
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|