For those of you fitting the cleat bevel blocks (the ones that go on either
side of the CB hole) You need to re-inforce the holes and use RF20151 A's,
not RF20151's. The RF 20151's can only take a #6 wood screw directly into
the wood of the bevel blocks. We are placing a large force on the cunningham
block and this could pull out of the wood if it uses a #6 screw. The ideal
solution would be to put an 8-32 T-nut under the cleat bevel blocks to help
with the load.
Roger
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|