img_6190 (10/11)

Close up. I pretty much nailed the points I wanted to come out at. Notice how much further in these two are - the old holes are going to be cut right out. For this reason, I didn't bother removing the entire backing plate - there's enough plate here that these won't have any issues. (I also considered adding in another layer, but that too didn't seem worth it once I saw how much further in these holes were.) The tee-nuts don't even touch the previous holes. Also note that I've removed the old tee-nut backing pieces -- I sanded off the containing s-glass, and then hit them edge-on with a hammer and screwdriver. Sand that down, and there's a flat surface for mounting the new tee-nuts.

Mar 18, 2006 - 15:59