Hi all,
This just to agree with Bram & Ron's recent points. No personal CNC
experience, but I think CNC'd stations would be mainly a time-saver. Only
second more of an easy almost guarantee of fair boat lines. I would think
any of us spending this much money (& time) is going to do a damn careful
job and can saw to within 1mm of the final line. Followed up with
hand-sanding I hope to be within 0.5mm. Perhaps the point of concern is that
while this may get you successfully Measured, there may still be a
competitive difference in the final fairness. However, I would think there
are more than enough other similar construction micro-differences through
the whole building process to make this a moot point.
Good work on the rules.
cheers,
Paul Stalker
|