To: | <swiftsolo@xxxxxxxxxxxx> |
---|---|
Subject: | Jib Tract Alignment Tip |
From: | "Rob DesMarais, D.C." <drrld@xxxxxxxxxxx> |
Date: | Sun, 5 Feb 2006 22:41:24 -0600 |
Importance: | Normal |
In-reply-to: | <01a201c62937$2b8a93c0$0200a8c0@markkrtsykx0qx> |
12" clamps on each side (see picture) do an excellent job holding the tract while you sight it. (36" up from forestay fitting) Wedges on each end can move forward and aft while you fine tune it. The clamps can move toward the center line if you don't have enough height or outward to decrease the height. Rob
IMG_0380.JPG This is the Swift Solo mailing list. For unsubscribe instructions, visit here: http://catzooks.com/swift-solo/ |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: non slip tape, Keith Councell |
---|---|
Next by Date: | plumber, Mark White |
Previous by Thread: | Re: non slip tape, Keith Councell |
Next by Thread: | Flanges/forestay bolts, Rob DesMarais, D.C. |
Indexes: | [Date] [Thread] [Top] [All Lists] |