swift-solo
[Top] [All Lists]

bow shape

To: <swiftsolo@xxxxxxxxxxxx>
Subject: bow shape
From: "Mark" <mark@xxxxxxxxxxxxxxxxxxxxxx>
Date: Mon, 28 Jun 2004 14:36:09 -0600
Warren,

here is a picture of the bow piece in place,  notice station 1/2 below the 
strips.  I cut the hull at 90 degrees, it could have been cut at more of an 
angle sloping back and up aft from the deck line, the last strip at the deck 
line about an 1 to 1 1/4 inches longer.  the strips immediately above (below) 
the nose piece are not overlapping and need a fillet and glass reinforcement.  
the whole thing gets rounded off (by sanding) after the nose piece is 
installed.  you will end up with a gap between the bow shape form and the hull, 
between the keel line and the bow line, right in the curve.  it gets filled 
later.  i hope this helps.

Sincerely,

Mark

Attachment: P6280014.JPG
Description: JPEG image

This is the Swift Solo mailing list.  For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
<Prev in Thread] Current Thread [Next in Thread>

This is the Swift Solo mailing list archive. Visit here to see instructions on how to subscribe and unsubscribe from the list, and to browse the mailing list archives.