To: | <swiftsolo@xxxxxxxxxxxx> |
---|---|
Subject: | Bow Profile & Trimming the hull?? |
From: | "Rob DesMarais, D.C." <drrld@xxxxxxxxxxx> |
Date: | Wed, 29 Jun 2005 11:11:34 -0500 |
Importance: | Normal |
In-reply-to: | <BAY102-DAV4E2503C7DA4844729BC9ACAEC0@phx.gbl> |
On the Bow Profile Pattern, the line that says ?Bottom of Spinnaker Pole Saddle?, will this point be where I would start to mark the hull strip and then draw a line to Station ½ and cut the hull accordingly (as explained in trimming and preparing the hull)? Thanks for any tips. Rob |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Transom Bar, Rob DesMarais, D.C. |
---|---|
Next by Date: | Fwd: Fatigue Tests Underway, BDally6107 |
Previous by Thread: | Re: Testing the new lightweight centerboard, Greg Ryan |
Next by Thread: | Transom Bar, Rob DesMarais, D.C. |
Indexes: | [Date] [Thread] [Top] [All Lists] |