| To: | "Rob DesMarais, D.C." <drrld@xxxxxxxxxxx>,<swiftsolo@xxxxxxxxxxxx> |
|---|---|
| Subject: | Re: Forestay fittin' |
| From: | "Greg Ryan" <gregoryrryan@xxxxxxxxxxx> |
| Date: | Wed, 18 Jan 2006 01:46:51 -0500 |
| References: | <00d701c61bab$7aa30760$0201a8c0@OFFICE> |
The center hole in the vertical tang on the 49er part is where the forestay is
normally attached. Therefore the measurement is made from the bearing surface
of the forestay attachment point. If you are using a NYC Skiffs forestay
fitting it makes complete sense to use the bearing surface of the forestay
attachment point.
Greg.
----- Original Message -----
From: Rob DesMarais, D.C.
To: swiftsolo@xxxxxxxxxxxx
Sent: Tuesday, January 17, 2006 4:17 PM
Subject: RE: Forestay fittin'
Center of the forestay fitting it is. Thanks Robert and Bram.
Rob
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: Forestay fittin', Rob DesMarais, D.C. |
|---|---|
| Next by Date: | Fwd: Please Post, Warren Stevens |
| Previous by Thread: | RE: Forestay fittin', Rob DesMarais, D.C. |
| Next by Thread: | S glass question and an east coast regatta, Steven Harrington |
| Indexes: | [Date] [Thread] [Top] [All Lists] |