Bram - how are you determining alignment? Do you lay a full length
strip down lengthwise and see where it misses the station forms?
On Sun, Apr 11, 2004 at 11:13:18PM -0400, BDally6107@xxxxxxx wrote:
> Warren,
>
> You'll need to be closer than that. You will have a problem when the
> assembly is right side up with station 11 (if I remember correctly) being
> a bit low and will have to move it up. When the assembly is upside down
> it should be right on except that when you run the gunwale you'll need to
> add a small shim or two in the forward station outer ends. When you bend
> a couple of full length strips there should be no bumps when you sight
> down it.
>
> I hope this helps -- I'm a little tired.
>
> Regards,
>
> Bram
--
warren stevens - catzooks.com
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|