Ok -- I'm aligning my station forms (yay!). Using a number of
different methods, I figure at most one form is out by at most 3 mm
(say, 1/8"). Is this accurate enough? (How accurate did you get your
alignment?)
I have drilled 3/8" holes through all the stations and can sight a
laser level through the holes on both sides; on the last station the
laser hits maybe 2mm from the hole.
I have clamped shims onto the w/l and then laid a strip along the
shims, and measured the distance from the strip to the shim; at most
3mm out on one, and most others are 0 or 1 mm.
I have very carefully sighted the length of the wings and ensured that
all of them match port to sb.
Any other hints? The real problem with this is that if I go in and
make a change, I'm afraid I'll be worse off than when I started...
Thanks
Warren
--
warren stevens - catzooks.com
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|