Hi Bram,
Did you say there was an updated manual on the website with corrections in
PDF? I looked but couldn't find one?
To your health,
Rob
-----Original Message-----
From: BDally6107@xxxxxxx [mailto:BDally6107@xxxxxxx]
Sent: Sunday, April 11, 2004 11:36 PM
To: warren@xxxxxxxxxxxx
Cc: swiftsolo@xxxxxxxxxxxx
Subject: Re: aligning station forms
Warren,
Take a couple of full length strips and temporarily staple them in a
straight line near the step on each side. Sight them for vertical waviness.
If you see any, you need to adjust the stations until the waviness
disappears.
Regards,
Bram
|