Hi All,
Chain plate
What length and size bolts is being used for chain plate block thru the deck?
Three per side, approx. spacing? Obviously stainless, embedded t-nut in c/p
block. Yes
are hex nuts and washer used to clamp the deck to hull? Then fabricate the 11
layered cap?
What's the distance of outer edge of chainplate block at midpoint to outer
edge of gunwale? To establish position for bonding.
What bit size is used for the righting line hole thru the chainplate block?
is this fore or aft from station 7; to first or after the last bolt?
Probably doesn't matter. It all leverage, answering the last part of
this question.
Bow sprit
What length of the four bowsprit 1/4 inch bolts should I use?
What's the size and length of the two bow joining screws?
Regards ken
|