To: | Mark@xxxxxxxxxxxxxxxxxxxxxx, gregoryrryan@xxxxxxxxxxx, drrld@xxxxxxxxxxx, swiftsolo@xxxxxxxxxxxx |
---|---|
Subject: | Re: Tiller Layup & Centerboard and Rudder layup |
From: | BDally6107@xxxxxxx |
Date: | Wed, 21 Dec 2005 19:21:50 EST |
Mark, You are correct. All pieces go to the top of the blade because that is where the load is highest. There is no specific engineers specifications on these so we are just using our best judgment. On the rudder make one of the short layer go past the bottom of the cassette a couple of inches and the other short layer go halfway from there to the tip. Best regards, Bram |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Tiller Layup & Centerboard and Rudder layup, Mark White |
---|---|
Next by Date: | Re: Tiller Layup & Centerboard and Rudder layup, Mark White |
Previous by Thread: | cb trunk, Mark White |
Next by Thread: | Re: Tiller Layup & Centerboard and Rudder layup, Mark White |
Indexes: | [Date] [Thread] [Top] [All Lists] |