In a message dated 1/9/2007 11:10:42 PM Eastern Standard Time, lindsey@xxxxxxxxxxx writes: > Swifties, > > I have mounted most of my deck hardware using using SS "T" nuts (10-24). > Bonding the T nuts with epoxy and high density filler. I assume most or all > of us have done it this way. > > I would like to know what the spinnaker sheet ratchet is? Ratchet? On > page five of my manual, third picture at the top shows a Spin Sheet Block. > Is this the same hardware part. It is located at 114" and 31" s/p. Ratchet? > I don't have any ratcheting blocks other than the one which is mounted under > the boom. > > Dave Lindsey > British Columbia, Canada > CAN 046 > Dave, Attached is a picture of the spin sheet ratchet blocks and tennis ball. The ball is flipped up to show the eyestrap and D-shackle. I used a saddle ferrule eye and tied the shackle pin to prevent loss. The eyestrap is mounted to 10-32 T-nuts and large backing plate, with large fender washers. The ratchet block has a switch to enable/disable the ratchet. Bill Scheumann USA020 and USA040
This is the Swift Solo mailing list. For unsubscribe instructions, visit here: http://catzooks.com/swift-solo/ |
