Dear All,
Where do you folks get your 1/8" PBO from ?
regards
Patrick
-----Original Message-----
From: Christian Rasmussen [mailto:christian@xxxxxxxxxxxxx]
Sent: Wednesday, May 12, 2004 12:42 AM
To: rowr
Cc: swiftsolo@xxxxxxxxxxxx
Subject: Re: chain plate
*** WARNING ***
This mail has originated outside your organization,
either from an external partner or the Global Internet.
Keep this in mind if you answer this message.
Roger,
Thats what I did. I used middle and outers. I dont have a tally on the
number of screews I used. I am sticking to 10-24 for everything except the
chainplates where I did 1/4. The lenght will vary but I have been buying 3"
and just cutting them off after I bolted them in.
Christian
----- Original Message -----
From: rowr <rowr@xxxxxxxxx>
Date: Tuesday, May 11, 2004 7:32 pm
Subject: chain plate
> A question about the chainplate. Is it correct that we are using
> rudder gudgeons as deck attachments for the chainplates and if so,
> I presume we use the centre hole and the two outmost holes for
> fitment.
> Secondly, has anyone made a consolidated list of bolts, screws and
> rivets that are used for the deck fittings. I assume also that all
> the bolts, screws and t-nuts are stainless.
>
> regards and good building
> Roger - CAN048
>
>
>
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender.
You should not copy it or use it for any purpose nor disclose or
distribute its contents to any other person.
********************************************************************
This is the Swift Solo mailing list. For unsubscribe instructions,
visit here: http://catzooks.com/swift-solo/
|