Re: Spin Pole

[BDally6107@xxxxxxx]

Rob,
 
Greg likely has your Holt Allen fitting along with the fittings for your  
boom and mast.  The "spar kit" includes the fittings for the pole.  I  don't 
have 
my HA book right here but I think Marks part number rings a  bell.
 
It is good to sand and wrap the end 5" of your pole with a 1 1/2 wraps  of 
woven carbon or s-glass.  Overlap it equally on both sides of where you  intend 
to cut the hole for the fitting.
 
I hope this helps.  Sounds like you are getting close to getting it  wrapped 
up!!  I look forward to seeing you in Florida.
 
Best regards,
 
Bram