In a message dated 9/19/2005 6:24:16 AM Pacific Daylight Time, WFS03@xxxxxxx
writes:
There is a staple gun available that shoots polyester staples which are
light brown in color. You simply sand off the tops and thus the holes are
already filled. The hull or deck is then cut off of the forms from below with
a
razor blade, once the s-glass has been installed. This technique was used in
building USA020. For anyone interested, contact me for the distributor's
address.
Bill, I wondered about this method. Isn't it a pain in the ass to crawl
around under the station assemble and try to lift the hull away from the forms
far enough to cut the staples without doing damage to the hull? Were you
able to avoid using any screws at all during the process?
Bram
|